Camcorderbatterypack.co.uk sells discount power tool batteries for most every power tool on the market. All power tool batteries are specifically designed for each power tool brand and model. Please Select your manufacturer.
If my original power tool battery is a NiCD battery, can I use a different chemistry battery?
That would depend on both your charger and power tool. A lot of chargers will charge NiMH batteries, and a few others will charge Li-Ion. However, even if your charger will do this, your power tool might not. It is best in these situations, to check your user manual or contact the manufacture to find out the technical specs of your model.
How can a standard automotive or marine battery's state of charger be accurately measured?
The state of charger of a lead acid battery is most accurately determined by measuring the specific gravity of the electrolyte. This is done with a hydrometer. Voltage also indicates the level of charger when measured in an open circuit condition. This should be done with a voltmeter. For an accurate voltage reading, the battery should also be allowed to rest for a period sufficient to let the voltage stabilize.
Do I have to condition my Laptop or Notebook battery?
Yes, it is very important to condition or fully discharger and then fully charger the battery every two to three weeks. Failure to do so may significantly shorten the battery's life (this does not apply to Li-ion batteries, which do not require conditioning). To discharger, simply run the device under the battery's power until it shuts down or until you get a low battery warning. Then recharge the battery as instructed in the user's manual
What is the difference between MCA and CCA?
The marine cranking ampere (MCA) rating of a battery is very similar to the CCA rating; the only difference is that while the CCA is measured at a temperature of 0°F, the MCA is measured at 32°F. All other requirements are the same the ampere draw is for 30 seconds and the end of discharger voltage in both cases is 1.20 volts per cell.
