Power tool batteries are specifically designed for each power tool brand and model. Camcorderbatterypack.co.uk offers a wide selection of power tool batteries and compatible replacements for most power tools. Please select your power tool brand from the list below.
This battery should only be charged by APT002, which is specially designed by our company; and the charger APT002 must not be used for original Ni-MH, Ni-Cd tool batteries.
*** If you need a part for your model that is not listed above, please email us at info@camcorderbatterypack.co.uk or call our Tel: 01772 454688
1 year warranty!
15 Days Money Back.
100% brand new.
100% Secure Shopping Guarantee.
Payment Methods:Check, SEC, Paypal, Bank Transfer.
How to connect a battery in Series?
The positive terminal of the first battery is connected to the negative terminal of the second battery, the positive terminal of the second is connected to the negative of the third, etc. The voltage of the assembled battery is the sum of the battery voltages of the individual batteries. So the batteries are connected: + to - to + to - to + to -, etc. The capacity of the battery is unchanged.
How do I Jump Start my Battery using booster cables?
WARNING-BATTERIES PRODUCE EXPLOSIVE GASES. These instructions are designed to minimize the explosion hazard. Keep sparks, flames and cigarettes away from batteries at all times. Both batteries should be of the same voltage (6, 12, etc.).
How Can I Maximize Power Tools Battery Performance?
There are several steps you can take to insure that you get maximum performance from your battery:
Breaking In New Batteries - new batteries come in a discharged condition and must be fully charged before use. It is recommended that you fully charge and discharge your new battery two to four times to allow it to reach its maximum rated capacity.
Preventing the Memory Effect - Keep your battery healthy by fully charging and then fully discharging it at least once every two to three weeks. Exceptions to the rule are Li-ion batteries which do not suffer from the memory effect.
Keep Your Batteries Clean - It's a good idea to clean dirty battery contacts with a cotton swab and alcohol. This helps maintain a good connection between the battery and your portable device.
Exercise Your Battery - Do not leave your battery dormant for long periods of time. We recommend using the battery at least once every two to three weeks. If a battery has not been used for a long period of time, perform the new battery break in procedure described above.
Battery Storage - If you don't plan on using the battery for a month or more, we recommend storing it in a clean, dry, cool place away from heat and metal objects. Ni-Cd, Ni-MH and Li-ion batteries will self-discharge during storage; remember to break them in before use. Sealed Lead Acid (SLA) batteries must be kept at full charge during storage. This is usually achieved by using special trickle chargers. If you do not have a trickle charger, do not attempt to store SLA batteries for more than three months.
What is the Amp Hour (Ah) rating?
An amp-hour is one amp for one hour, or 10 amp for 1/10 of an hour and so forth. It is amp X hours. If you have something that pulls 20 amp, and you use it for 20 minutes, then the amp-hours used would be 20 (amp) X .333 (hours), or 6.67 AH. The accepted AH rating time period for batteries used in solar electric and backup power systems (and for nearly all deep cycle batteries) is the "20 hour rate". This means that it is discharged down to 10.5 volts over a 20 hour period while the total actual amp-hours it supplies is measured. Sometimes ratings at the 6 hour rate and 100 hour rate are also given for comparison and for different applications. The 6-hour rate is often used for industrial batteries, as that is a typical daily duty cycle. Sometimes the 100 hour rate is given just to make the battery look better than it really is, but it is also useful for figuring battery capacity for long-term backup amp-hour requirements.
