Camcorderbatterypack.co.uk offers a wide selection of PDA batteries and compatible
replacements for most PDA. Please select your PDA brand from the list below.
Please ensure the palmone pda battery that you are going to buy fits the brand, model and part number of your device.
This pda battery can replace the following part numbers:
PALMONE:
CA4TREO600, EPNN7911A, PA1547.
This pda battery is compatible with the following models:
PALMONE:
Treo 600, Treo 610.
NOTE:
*** If you need a part for your model that is not listed above, please email us at info@camcorderbatterypack.co.uk or call our Tel: 01772 454688
1 year warranty!
15 Days Money Back.
100% brand new.
100% Secure Shopping Guarantee.
Payment Methods:Check, SEC, Paypal, Bank Transfer.
Shipped out within 0.5-10 hours at Office time.
Receive your item in 1-5days.
Palmone PDA Battery Tips
What is sulfation of batteries?
Sulfation is the formation or deposit of lead sulfate on the surface and in the pores of the active material of the batteries' lead plates. If the sulfation becomes excessive and forms large crystals on the plates, the battery will not operate efficiently and may not work at all. Common causes of battery sulfation are standing a long time in a dischargerd condition, operating at excessive temperatures, and prolonged under or over charging.
How to connect a battery in Parallel?
The positive terminal of the first battery is connected to the positive terminal of the second battery, the positive terminal of the second is connected to the positive of the third, etc. The negative terminal of the first battery is connected to the negative terminal of the second battery, the negative terminal of the second is connected to the negative of the third, etc. So the batteries are connected: + to + to + and - to - to -. In this configuration, the capacity is the sum of the capacities of the individual batteries and voltage is unchanged. For example, if you take 5 6V 10AH batteries and connect the batteries in series, you would end up with a battery array that is 30 Volts and 10AH. If you connect the batteries in parallel, you would end up with a battery array that is 6 Volts and 50AH. By the way, this is how ordinary auto batteries are made. 6 2volt cells are put in series to give 12v battery and the 6 cells are just enclosed in one case. Many ni-cad batteries are done the same way.
Do I ever add acid to my battery?
Under normal operating conditions, you never need to add acid. For a standard auto or marine battery, only distilled, deionised or approved water should be added to achieve the recommended levels mentioned above. When a battery is shipped in a dry state or accidental spillage occurs, electrolyte should be added to the battery. Once filled, a battery should only need periodic water addition.
New laptop batteries are hard for the device to charger; they have never been fully charged and are therefore "unformed". Sometimes the device's charger will stop charging a new battery before it is fully charged. If this happens, remove the battery from the device and then reinsert it. The charger cycle should begin again. This may happen several times during the first battery charger. Don't worry; it's perfectly normal.
