Please ensure the vivitar digital camera battery that you are going to buy fits the brand, model and part number of your device.
This digital camera battery can replace the following part numbers:
VIVITAR:
CR123A.
NOTE:
This battery RCR123A can only be charged by our charger. You must buy 1pc CFR001 (battery and charger) from our site before ordering this battery.
Related Products Buying Leads
*** If you need a part for your model that is not listed above, please email us at info@camcorderbatterypack.co.uk or call our Tel: 01772 454688
1 year warranty!
15 Days Money Back.
100% brand new.
100% Secure Shopping Guarantee.
Payment Methods:Check, SEC, Paypal, Bank Transfer.
Shipped out within 0.5-10 hours at Office time.
Receive your item in 1-5days.
Together is Better!
Buy this item with the vivitar battery charger, you can buy these items with very nice price!
Can I take a wheelchair, scooter or other equipment that is powered by a sealed AGM or Gel battery on a airplane or cruise ship?
Yes. There should be no problem, the battery is considered non-spill able, non-hazardous, since it is a absorbed glass mat design. These sealed lead acid valve regulated (VRLA) batteries are classified as "Battery, wet non-spill able, not subject to regulations" by DOT and IMO. By IATA they are classified as "Not restricted for air transport" and they are in compliance with IATA/ICAO special provision A67. For the gelled electrolyte batteries, they are classified as "Battery, wet, filled with acid, UN2794, Class 8". They can be legally shipped via air with special packaging etc.
What is the difference between MCA and CCA?
The marine cranking ampere (MCA) rating of a battery is very similar to the CCA rating; the only difference is that while the CCA is measured at a temperature of 0°F, the MCA is measured at 32°F. All other requirements are the same the ampere draw is for 30 seconds and the end of discharger voltage in both cases is 1.20 volts per cell.
Can batteries freeze?
In a partially discharged state, the electrolyte in a lead acid battery may freeze. At a 40% state of charger, electrolyte will freeze if the temperature reaches approximately ?6.0°F. The freezing temperature of the electrolyte in a fully charged battery is -92.0°F.
How Can I Maximize Power Tools Battery Performance?
There are several steps you can take to insure that you get maximum performance from your battery:
Breaking In New Batteries - new batteries come in a discharged condition and must be fully charged before use. It is recommended that you fully charge and discharge your new battery two to four times to allow it to reach its maximum rated capacity.
Preventing the Memory Effect - Keep your battery healthy by fully charging and then fully discharging it at least once every two to three weeks. Exceptions to the rule are Li-ion batteries which do not suffer from the memory effect.
Keep Your Batteries Clean - It's a good idea to clean dirty battery contacts with a cotton swab and alcohol. This helps maintain a good connection between the battery and your portable device.
Exercise Your Battery - Do not leave your battery dormant for long periods of time. We recommend using the battery at least once every two to three weeks. If a battery has not been used for a long period of time, perform the new battery break in procedure described above.
Battery Storage - If you don't plan on using the battery for a month or more, we recommend storing it in a clean, dry, cool place away from heat and metal objects. Ni-Cd, Ni-MH and Li-ion batteries will self-discharge during storage; remember to break them in before use. Sealed Lead Acid (SLA) batteries must be kept at full charge during storage. This is usually achieved by using special trickle chargers. If you do not have a trickle charger, do not attempt to store SLA batteries for more than three months.
